OBDII
  OBDII (1996 and up)
  check engine code 441, possible solutions

Post New Topic  Post A Reply
profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone! next newest topic | next oldest topic
Author Topic:   check engine code 441, possible solutions
patel455
Junior Member
posted 12-27-2004 12:55 PM     Click Here to See the Profile for patel455     Edit/Delete Message   Reply w/Quote
Hi,
I have Toyata Carola 98, 75000 mile.
My car has engine check light. I have checked the OBDII code is 441,
Which says it "EVAP system purge flow problem".

I have tried to replace the new Gas Cap. But the problem is not gone.

Can any one provide list of things I should check with mechanics,
Instead of going for car dignostics.

Next thing I am trying is to check for Vaccum Leak. I am on right direction?

Now my car doesn't start well. It makes tick sound during 1 or 2 times. Than starts ok. I don't because of Cold Whether / Battery / Carbon accumalated in engine by 441 problem.

Thank you for your time.
Thanks

IP: Logged

carfixer
Member
posted 01-01-2005 03:06 PM     Click Here to See the Profile for carfixer     Edit/Delete Message   Reply w/Quote
A clicking starter would most likely be a bad solenoid.
Check all plumbing for evap system to address the P0441 code.

IP: Logged

patel455
Junior Member
posted 01-03-2005 08:24 AM     Click Here to See the Profile for patel455     Edit/Delete Message   Reply w/Quote
Hi,
Can I able to replace solenoid valve & give a try?

Do I need to do go to mechanic to check evap pumping?

Thanks,
Avin Patel

IP: Logged

jacob_psu_auto
Junior Member
posted 01-03-2005 09:37 PM     Click Here to See the Profile for jacob_psu_auto   Click Here to Email jacob_psu_auto     Edit/Delete Message   Reply w/Quote
First off if you don't know what your doing don't do it. The starter solinoid is on the starter and is replaced by buying a new starter but check battery first. Could be a dead cell in the battery. Second yes a mechanic needs to check the EVAP plumming. And no vaccum leak has nothing to do with it. The code is set when the vaccum in the tank does not drop when canister purge is requested.

IP: Logged

patel455
Junior Member
posted 01-04-2005 09:10 AM     Click Here to See the Profile for patel455     Edit/Delete Message   Reply w/Quote
Thank you, that helped a lot.

IP: Logged

All times are CT (US)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | OBDII Home Page

Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45c

The OBD-II Home Page is hosted by B&B Electronics of Ottawa, Illinois